WARNING: DISCONNECT ALL POWER AND ALLOW SYSTEM TO SIT IDLE FOR AT LEAST TEN MINUTES BEFORE WORKING ON YOUR MONITOR

Installing ezscreen kits for CRTs

Step Four: Putting It Back Together

Replace bezel using the main bezel screws. Be sure not to pinch any of the attached wiring.

Re-attach all wires to their original places and attach the touchscreen ground wire to a ground mount within the monitor.

 

Using cable-ties, attach the four-pin connector cable to existing wires in the monitor to prevent its being accidentally pulled loose once the monitor is reassembled.

Once all the wires are reattached and the controller cable is firmly tied into place it is time to replace the rear housing.

Now just plug the system into your computer and install the driver software!

Return the EZscreen Homepage>