Working on a smooth, compliant surface, turn the
monitor on its side to locate and remove the cabling access panel. (Exits for the cables
vary from manufacturer to manufacturer)WARNING: DISCONNECT ALL POWER AND ALLOW SYSTEM TO SIT IDLE FOR AT LEAST TEN MINUTES BEFORE WORKING ON YOUR MONITOR
Installing ezscreen® kits on CRTs
Step One:Removing the Monitor's Rear Housing
Working on a smooth, compliant surface, turn the
monitor on its side to locate and remove the cabling access panel. (Exits for the cables
vary from manufacturer to manufacturer)
The housing is typically manufactured in two halves.
These halves are usually held together by four phillips head screws. Locate and remove
these screws.
Now
turn the monitor so that the screen is face down.You should now be able to remove
(carefully) the rear portion of the housing